Implementation and Configuration INSYS WLAN bridge
15
the PC can be reset to the previous IP address. The PC and the INSYS WLAN bridge can
then be reconnected normally with the network.
Note:
At all events, avoid the LAN connection of the AccessPoints and the LAN
connection of the INSYS WLAN bridge being connected to the same network.
This will lead to bridging of the packets into the same network and to serious
malfunctions in the network and subsequently also to serious problems with
your system administrator.
If the IP address has accidentally been adjusted and/or is not known, the INSYS WLAN
bridge can also be reset to the factory settings without the web interface, using the
RESET key. See Chap. 5.3.
5.4.3 Configuration Page Status
The status page displays the current state of the INSYS WLAN bridge
.
In detail, the following information is provided:
Connected to SSID:
SSID of the remote terminal (AccessPoint or another bridge in
adhoc mode), to which the module has a connection
HF channel:
Currently used channel
MAC address of the AP:
MAC address of the remote terminal (adhoc) or of the
AccessPoint
Data rate (Mbits/s):
Currently reached data rate
Signal power (%):
Current quality of the received signal level – the signal should
be more than 20%
Own MAC address:
MAC address of the INSYS WLAN bridge
version 1.01 / 10.04
