Instruction Manual IGM402 Hornet
InstruTech
Page 65
COMMAND
BRIEF DESCRIPTION
COMMAND SYNTAX
RESPONSE
SET COMMS BAUD
RATE
Set the communications
baud rate for the unit.
(1)
Message Length: 5 bytes
!<01><20><xx><CRC>
<cmd>: 0x20
<xx>: represents the byte value as
follows for various baud rates:
00:
300
01:
600
02:
1200
03:
2400
04:
4800
05:
9600
06:
14,400
07:
19,200
08:
28,800
09:
38,400
0A:
57,600
*<01><20><xx><CRC>
RESET UNIT
Reset the unit as if power
has been cycled from off
to on.
Message Length: 5 bytes
!<01><22><xx><CRC>
<cmd>: 0x22
<xx>: represents the byte
No response from unit.
READ CG1 VACUUM
SETTING VALUE
Gets the CG1 vacuum
pressure setting.
Message Length: 8 bytes
!<01><2D><xx><xx><xx><xx><CRC>
<cmd>: 0x2D
<xx>: represents the four byte
floating point value place holder.
*<01><2D><yy><yy><yy>
<yy><CRC>
<yy>: represents the four byte
floating point value.
SET CG1 VACUUM
SETTING VALUE
Sets the CG1 vacuum
pressure setting.
Message Length: 8 bytes
!<01><2C><xx><xx><xx><xx><CRC>
<cmd>: 0x2C
<xx>: represents the four byte
floating point value.
*<01><2C><xx><xx><xx>
<xx><CRC>
READ CG2 VACUUM
SETTING VALUE
Gets the CG2 vacuum
pressure setting.
Message Length: 8 bytes
!<01><2F><xx><xx><xx><xx><CRC>
<cmd>: 0x2F
<xx>: represents the four byte
floating point value place holder.
*<01><2F><yy><yy><yy>
<yy><CRC>
<yy>: represents the four byte
floating point value.
(1)
Commands marked with a (1) under the “BRIEF DESCRIPTION” column will not take effect until after RESET
command is sent or power is cycled.
