48
•
Connect
Output 2
to the input of a VCA for attenuated level control
of the wet signal. Set to a desired amount.
•
Set the
Layer
knob to the desired target layer.
•
Press the
Capture Button
or connect a gate signal to the
Capture
Gate Input
to start capturing audio.
•
Capture will be activated until the maximum layer duration has been
met. If the
Capture Button
is pressed while capture is activated, or if
the gate signal present at the
Capture Gate Input
is low, recording
will be stopped.
•
Once capture has deactivated, turn the
Input Level
fully anticlockwise.
•
Monitor the summed output (In the graphic above the summing is
achieved by linking two
v
in
câ’s via their back jacks).
Control Path:
•
Ensure the
CV Expansion Module
is connected to
arbhar
via the 12
pin IDC ribbon cable.
•
Apply control voltage to the
MOD CV Input
to control
arbhar
’s
curated
Feedback/Delay
parameter
