STEP 12
Coupler attachment for bikes with quick-release rear axles.
(Note: If your rear bike tire has two hub nuts please refer to Steps 10 & 11.)
12A
12B
12C
12D
12A. Flip open the quick-release lever, and remove the nut and spring from the opposite side.
12B. Hold the lever and pull the axle skewer with spring out.
12C. Completely remove the skewer but leave the wheel in place.
12D. Slide the coupler plate and tab washer onto the skewer. IMPORTANT! The wide end of the
spring should face out and touch the lever, the bell of the coupler plate should face out, and the
tab washer hook should face in toward the wheel hub.
STEP 13
Attach trailer tow bar to bike
13A
13B
13C
13D
13A. Insert end of skewer through wheel hub and fit tab washer hook into slot in bike frame dropout.
13B. Replace the spring (wide end out) over the end of the skewer, followed by the nut. Tighten the
nut by hand and clamp the lever down (F).
13C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.
13D. IMPORTANT! Loop the safety strap around the bike frame and clip the end into the “D” ring at
the end of the tow bar (H).
WARNING
Safety strap must attach to the bike frame when using this product in trailer mode.
7
