Step 2. Rear Wheel Assembly
Turn stroller onto its side. Grasp rear wheel in one
hand,
slide wheel’s axle into the sides of the rear “ U “
shaped crossbar hole located near the rear brake.
Push firmly to lock in place. (Figure B1). Check to
see that the wheel is properly inserted by pulling on
the wheel firmly. The wheel should not come off if fully
inserted/locked. Repeat for other side. To release
wheel push up on axle release lever and pull off wheel
(Figure B2).
Model M3 Strollers Assembly Instructions
Parts List
Description Qty
Frame Assembly 1
Fender 1
Fender screws # 8 x 3/4" 4
Parent Console 1
Front Wheel Assembly 16" 1
Rear Wheels 16" 2
Stroller Assembly Instructions
Step 1. Unfold Stroller
Grasp frame as shown and open until both
side latches engage (Figure A).
Fig. A
Fig. B1
Fig. B2
Rear Axel
Axel Hole
Release Lever
Step 3. Front Fender Assembly
Turn stroller upright onto its rear wheels, then tip
stroller back so the handlebar is down on the
ground and the front fork is up. Align the fender’s
4 boss’s with the 4 holes on the front frame push the
4 boss’s into the frame’s hole. Insert the
#8 x 3/4" screw into the hole and tighten with a
Phillips screwdriver, repeat for the other 3 holes
(Figure C).
Fig. C
Boss
Front Fender
Holes
