Rev. 7/16/2012 12:38 PM / See Owner’s Manual for Warranty Information, Patented
© Copyright 2012, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Add KeypadLinc Button as an INSTEON Controller
1)
Tap the KeypadLinc scene button of choice (doesn’t matter if you send an on or an off command)
2)
Press and hold KeypadLinc’s Set button until it beeps (about 3 seconds)
KeypadLinc scene button LED will blink
All illuminated LEDs on KeypadLinc will brighten to 100%
You will have 4 minutes to complete the next step before linking mode automatically times out
3)
Adjust the scene responder to the state you wish it to be at when the scene is activated from KeypadLinc (e.g.
50%, 25% or even off).
(Note: Manually tapping the responder’s button/paddle/etc. is required.)
4)
Press and hold the responder Set button until it beeps or its LED flashes
KeypadLinc will double-beep and its scene button LED will stop blinking
KeypadLinc LEDs will return to normal brightness
Responder LED will stop blinking (it may also double-beep)
5)
Confirm that scene addition was successful by tapping on/off on your chosen KeypadLinc button
The responder will toggle between the scene on-level and off
Add KeypadLinc Button as an INSTEON Responder
1)
Press and hold the scene controller (the other INSTEON device) button until it beeps
Controller LED will blink
2)
When the scene is activated:
•
If you want LED
on:
i. Tap KeypadLinc scene responder button until LED is on
•
If you want the LED off:
i. Tap KeypadLinc scene responder button until LED is off
3)
Press and hold KeypadLinc Set button until it double-beeps (about 3 seconds)
KeypadLinc scene button LED will flash once and return to its previous state
Controller will double-beep
and its LED will stop blinking
4)
Confirm that scene addition was successful by toggling the controller’s scene button on and off
KeypadLinc scene button LED will toggle between on and off
Owner’s Manual and Tech Support
Owner’s Manual and current Quick Start Guide:
http://www.insteon.com/support
Call: INSTEON Support Line at 800-762-7845
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
1
If the responder is a multi-scene device, tap the scene button you wish to control until its LED is in the desired state (on or off)
2
If the controller does not have a beeper, wait until its LED begins blinking
3
Load will mimic LED state for toggle buttons. For the ON and OFF buttons tap the desired scene state.
4
Most models
