4
21. To disconnect, turn any control to "off", then remove plug from wall outlet.
22. Do not place the unit on an unstable location it is strictly prohibited to use it on a
newspaper, foam or other object that may easily block the vent holes at the bottom.
23. Do not use it in a place which is near splash water or fire. Do not use it in a place exposed
to directly to sunshine or oil splash. Put it in a place out of the reach of children.
24. Before use each time, be sure to check the anti-block shield, float valve and exhaust valve
(steam release handle) for obstruction, wipe the surface of the inner pot and the heating
plate to confirm they are free of any foreign object; make sure the steam release handle is in
sealing position
.
25. Do not move this product or force to remove the lid when the unit is in operation.
26. Do not place your hands or face over the exhaust valve (steam release handle) or float
valve to avoid scald when the unit is in operation.
27. To reduce the risk of fire or electric shock, only authorized personnel should do repairs.
28. Do not cover the pressure valves.
29. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are
accompanied by a person responsible for their safety.
30. Do not use this product on any electrical system other than voltage: 110-120V~/60Hz.
PLEASE SAVE THESE INSTRUCTIONS.
And keep the user manual in a convenient place for future reference.
Precautions
Before each use, please make sure to inspect the following:
1. The anti-block shield, float valve and exhaust valve are not blocked by food debris.
2. The bottom surface of the inner pot and the heating plate are free of any foreign objects.
3. The steam release handle is in the "Sealing" position for all pressure cooking.
After cooking, wait until the cooker cools down for a while and release the pressure using the
steam release handle. Use extreme caution when opening the lid. Scald and serious burns can be
caused by the steam inside the unit.
If all LED lights are flashing on the control panel, unplug the power cord immediately and consult
the “Troubleshooting” section.
Care must be taken with the sealing ring to avoid deformation. Failure to do so may prevent the
product from working properly.
Special Cord Set Instructions
A short power supply cord is provided to reduce the hazards resulting from entanglement and
tripping. An extension cord may be used if care is exercised in its use. If an extension cord is used,
the electrical rating of the cord must be at least 12 amps and 120 volts. The extended cord must
be arranged so that it will not drape over edge of table or counter where it can be pulled by
children or tripped over accidentally.
