3
–
The products do not or cannot function normally even when you operate
according to the instructions.
•
If the system gets wet or damp, please follow steps below:
a.
Power off the equipment, disconnect them with the outlet, wait for 10 to 20
seconds, and then open the access panel.
b.
Move the equipment to a well-ventilated place to dry the system for at
least 24 hours and make sure that the system is fully dried.
c.
Close the access panel, reconnect the system to the power outlet, and then
power on.
d.
In case of operation failure or other abnormal situations, please contact
Inspur for technical support.
•
Avoid cabling system cables and power cords in high foot traffic locations. Please
do not place objects on the cables.
•
Before removing the access panel or accessing the internal components, please let
the equipment cool down first. To avoid damaging the motherboard, please power
off the system and wait for 5 seconds, and then remove components from the
motherboard or disconnect the peripherals from the system.
•
If there are modem, telecom or LAN options installed in the equipment, please pay
attention to the followings:
–
In case of lightning, please do not connect or use the modem. Otherwise,
there's risk of lightning stroke.
–
Never connect or use the modem in a damp environment.
–
Never insert the modem or telephone cables into the socket of network
interface controller (NIC).
–
Before unpacking the product package, accessing or installing internal
components, or touching uninsulated cables or jacks of the modem, please
disconnect the modem cables.
•
In order to avoid damages of electronic components in the equipment caused by
electrostatic discharge, please pay attention to the followings:
a.
Please remove any static electricity on your body before dismounting or
accessing any electronic component in the equipment, to prevent the static
electricity from conducting itself to the sensitive components. You may
remove the static electricity on your body by touching the metal earthing
objects (such as the unpainted metal surface on the rack).
b.
Please do not take static sensitive components that are not ready to be
installed or used out of the anti-static packages.
