22
The adjustment steps for poly V-belt:
a) Unplug all power supply and take off the base cover.
b) Loosen the four screws for the motor, adjust the V-belt tension bolts in clockwise direction,
and then tighten back the four screws for the motor.
Adjustment running belt:
a) Turn the speed to be 6km/h. for running
b) Turn the both tension screws located at the end of the treadmill on the right and left sides, half
a turn clockwise using the Allen key. (Diagram1 and Diagram 2)
c) After adjustment, running belt still slips; please repeat the steps as above.
Tighten the running belt (Diagram 1)
Loosen the running belt (Diagram 2)
The adjustment steps for running belt deflection:
The running belt will be deflected more or less under using. Then it needs to be adjusted. The steps
are as follows:
a) Place the treadmill on a horizontal floor, turn the speed to be 6 km/h for running.
b) If the running belt is deflected to the right, adjust the bolt on the right by turning it for half a turn
clockwise, then adjust the bolt on the left by turning it half an anti-clockwise. (see Diagram 3)
c) If the running belt is deflected to the left, adjust the bolt on the left by turning it for half a turn
clockwise, then adjust the bolt on the right by turning it half a turn anti-clockwise. (see
Diagram 4)
d) After the adjustment, the running belt still keeps deflecting, please repeat the steps above.
The adjustment for right deflection (Diagram 3)
The adjustment for left deflection (Diagram 4)
Running board lubrication- Silicone oil has been provided (White Bottle)
The treadmill is brand-new and has been pre-factory lubricated, but it is important to check the level of
oil before first use. Lubrication is not necessary directly after purchase.
Lubrication frequency:
•
Low use (lower than 3 hours per week)
– every 6 months
•
Moderate use (3-5 hours per week)
– every 3 months
•
Frequent use (more than 5 hours per week)
– every 2 months
•
Always use silicon oil inSPORTline.
The steps are as follows:
Step 1.
Please unplug power supply for the treadmill and loosen the belt (Belt tension screw located at
the end of the treadmill).
