7
CHARGING STEPS
Make sure the charging port is dry.
Open rear charge cover.
Put one end of charger into mains (100V ~ 240V, 50 60 Hz) and verify the indicator lights
green. Then put the other charger end into this device.
Red lighting indicator shows, that charging runs properly. If not, check connection.
If the red controller light changes in green the power is fully charged. Stop charging at this
time to protect battery lifetime.
Use only local approved plug.
Charge the battery continually.
Charging time is about 2 hours.
Don’t exceed it.
Keep the charging port and charger dry.
Don’t charge, if they are wet.
TEMPERATURE CONDITIONS
Correct temperature may have a big influence on function of this electroboard. Battery temperature
values must be within marked range.
Temperature before charging and in charging process must be within recommended range. Correct
temperature allows higher charging efficiency. Too high or too low temperature can prolong charging
time or cause charging insufficiency.
BATTERY PARAMETERS
Name
Parameters
Battery type
Lithium Battery
Charging Time
2 -3 hours
Voltage
36 V
Initial Capacity
2 - 4 AH
Operating Temperature
-
15°C ~ 50°C
Charging temperature
0
°C ~ 40°C
Storage Time (-
20°C ~ 25°C)
12 months
Storage Relative Humidity
5 % - 95 %
ATTENTION: Lithium batteries are considered dangerous goods. Its transport is under local
law. If you want to transport it by an airplane, contact the company or designated agents.