17
Item.
Malfunction
Reasons
Solution
1
Treadmill
can’t be
started
The safe key isn’t in the right
position
Put the safe key in the right position
The electrical switch is placed to
“0”
Turn the electrical switch to “1”
2
Meter can’t display
Check the machine whether it is in
power
Check the power cord are connected well
and switch on
The upper communication is
broken
Replace it!
The meter and upper
communication line are not
connected well
Disassembly meter and check the upper
communication line, make sure that
meter and communication line are
connected well.
3
Heart rate can’t be
displayed
The pole of heart rate sensor is not
wet enough
Wet the pole with water or liquor for
hard contact lenses
Disturbed by electromagnetism
Stay away from electromagnetism
4
Incline doesn’t work
The motor wire is not well
connected
Open the motor cover and reconnect it
5
Running
belt
runs
faster or slower than
what
has
been
displayed
Unadjusted
Readjust it
6
Running belt slips
Running belt is not tight enough
Please read point 6.3 Adjustment steps
for tightening running belt for reference
7
Running
belt
is
deflected
The running belt is unadjusted.
Please read point 6.4 The steps for
adjusting the deflected running belt for
reference
8
Displayed E01 on the
screen
The sensor wire or motor are
broken
Remove the motor cover and change the
sensor wire, motor in return
9
Displayed E02 on the
screen
Over power voltage protection
Use normal voltage.
10
Displayed E03 on the
screen
Over current protection
Check whether it is overloading
Check whether the drive motor can run
normally. If not, replace motor.
11
Displayed E04 on the
screen
The motor is not in power
The motor wire are not connected well or
the motor are broken
12
Displayed E06 on the
screen
Connection error
Changing the upper or lower connection
line
13
Displayed E09 on the
screen
Incline error
The incline motor wire are not connected
well or the incline motor are broken
14
Displayed E0P on the
screen
Speed error
Setting parameter wrong or sensor wire
broken
15
Displayed E0C on the
screen
Short-circuit protection
PCB MOS broken or motor broken
16
Displayed E07 on the
screen
Safety key off
Put safety key on the meter or change the
safety key or reed pipe for safety key
