How to use Panic Alarm
(PedoAlarm only)
-
Pull out the panic alarm pin from the unit to trigger the alarm.
-
Insert the panic alarm pin back to the
jack to stop the panic alarm instantly.
BATTERY REPLACEMENT
Ped Pulse
-
Release the battery compartment by unscrewing the secure screw
-
Pull out the battery with the help of fingernail.
-
Flip out the exhausted battery and replaced by new CR2032 x 1 (3V) battery. Make sure the
polarity is correct.
-
Put the battery compartment back and fasten the screw.
PedoFM
-
Flip up the clip and open the battery door by unscrewing the secure screw.
-
Flip out both exhausted batteries and replaced by new CR2032 x 1(3V) and CR1130 x 1(3V)
battery. Make sure the polarity is correct.
Close the battery door and fasten the screws.
PedoAlarm
-
Flip up the clip and open the battery
door by unscrewing the secure screw.
-
Flip out both exhausted batteries and
replaced by new CR2016 x 2(3V) and CR1130 x 1(3V)
battery. Make sure the polarity is correct. Close the battery door and fasten the screws.
CARE OF THE PEDOMETER
-
Avoid exposing the step counter to extreme temperatures.
-
-
Avoid taking a pulse reading while your finger is indirect sunlight (Strong sunlight will
generate interference through
the finger to the pulse sensor). Try to
cover your finger with your other hand when you need to take the pulse
reading under direct sunlight.
-
To clean the step counter, use a dry soft cloth of a soft cloth moistened in a solution of water and
a mild neutral detergent. Never use volatile agents such as benzene, thinner, spray cleaners, etc.
-
-
Store your step counter in a dry place when not in use.
-
Keep this manual and any other documentation that comes with the stepcounter in a safe place
for future reference.
