Insportline IN 21318, User Manual

Page: 16 / 23

16
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Treadmill will not start
Not plugged in. Plug the cord into the outlet.
Safety key not inserted. Insert safety key.
Running belt not centered
Running belt tension not proper
on the left or right side of the
running board. Tighten the adjustment bolts on
the left and right side of the rear
roller.
Computer not working
Wires from the computer and
bottom
control board not
properly connected.
Check wire connections from the
computer to the control board.
Transformer is damaged.
If the transformer has become
damaged,
contact customer
service.
E01 & E13: Communication
failure
No communication from console
to control board.
Check wire connections from the
computer to the control board
and replace wires and/or control
board if necessary.
E02: Burst clash protection
Incoming voltage is lower than
50% of the required voltage.
Check the incoming voltage
against the required voltage.
Check wire connections to the
motor. Check the control board,
replace if necessary.
E05: Current overload
protection (Self Protecting
System))
The incoming voltage is too low
or too high. The control board is
damaged.
Restart the treadmill. Check if
the incoming voltage is correct.
Check the control board, replace
if damaged.