10
2. Human-Machine Interface (HMI)
3. Motor
4. Control Shaft
5. Foot Platform (Silica Gel)
Get Started
To get started, adjust the control shaft of X3 to the upright position and parallelize the handlebar with
the platform. Open the rubber cap at the center of the platform and power on the unit before turning on
the remote control, and you’ll hear a beep prompt to indicate that the unit is ready to use. Put first one
foot on the platform then the other one after getting the beep prompt, and the unit is gyro-balanced and
good to go. In case the control shaft is biased severely to one side, or the platform is not on a horizontal
level, this indicates X3 is not ready to use. Get the unit in proper gyro-balanced state before getting on.
Kick Stand
X3 comes with a kick stand. For temporary parking, release the kick stand to park X3. You may also
buy and install it on your own.
Always release the kick stand when the unit is off. To prevent misuse of X3 by others, we strongly
suggest you power off the unit when you’re no around. In Addition, do not get on and steer X3 when the
kick stand is released, otherwise the kick stand can be damaged and may cause accidents.
New wireless remote key
A:
Turn on: press button A for 3 seconds
Headlights: Press button a for a second after the chariot boots up
Atmosphere lights: Press again for a second
Turn off headlights: Press A for second after all lights on.
Turn off atmosphere light: Press A again for a second
Turn off: Press A for 3 seconds after the driver getting off.
B:
Adjust the inclination of the chariot: Downward
C:
Special attention: Button C used by the engineer for factory settings. Never press it unless you
have professional guidance.
D:
Adjust the inclination of the chariot: Upward
Summary of Contents for IN 12570 Windrunner Handy X3
Page 1: ...USER MANUAL EN IN 12570 Windrunner Handy X3...
Page 13: ...13 APPENDIX I...
