16
12.0
– 14.5
Experienced runner.
14.5 and more
Excellent runner.
NOTE:
•
It is advisable for a walker to choose the speed of 6.0 km/h or lower.
•
It is advisable for a runner to choose the speed of 8.0 km/h or higher.
MAINTENANCE
WARNING!
•
Make sure that the power plug is pulled out before cleaning or maintaining this product.
•
Clean it properly to prolong product lifespan.
•
Remove dust regularly.
•
Clean the exposed belt parts to prevent dust from penetrating under the running belt.
•
Exercise only in shoes with clean and dry soles.
•
Never put any object to sockets and compartments or between the running belt and running
board.
•
Clean the running belt surface using a wet soapy cloth.
•
Protect it from water and liquids that could damage electric components under this belt.
•
First unplug this device from electric outlet before removing the motor cover.
•
Remove the motor cover and vacuum the space under this cover at least once a year.
LUBRICATION
The running belt and running deck are pre-lubricated. The belt/deck friction may play a major role in
the functionality and lifespan of this product. Thus, it needs periodical lubrication. We recommend do
regular inspection of the deck. If it is worn, contact the service.
NOTE:
•
You can buy lubricating oil from your local distributor or contact the producer.
•
To prolong product lifetime, we recommend powering off for 10 minutes every 2 hours of
running.
•
Too loose running belt can make you slip while running. Too tightened running belt can
influence negatively the motor performance and speed up wearing. The optimal state is, if the
running belt can be lift from the running deck about 50-75 mm.
MIDDLE PLACEMENT OF BELT AND TIGHTNESS ADJUSTMENT
It is necessary to adjust the belt for better usage. Treadmill with a well-adjusted belt can work better.
Put the treadmill running belt to the centre following next steps:
•
Put the treadmill on a level ground and let it run at speed of 6-8 mph (9-12 km/h). Observe
deviation of the running belt. If the running belt deviates right, pull out the safety key and
unplug this device from an electric outlet. Turn the adjusting bolt on the right side clockwise by
¼ circle. Then plug this device again and insert the safety key. Start the treadmill and let it run.
Check deviation again and repeat until the belt will be in the middle (Pic. A).