14
FLAT TIRE MAINTENANCE
WARNING:
Unplug the scooter and power it off before starting any maintenance.
•
Check that it is unplugged and powered off.
•
Place this device on a high, stable surface where there it is placed only on its body. The front
and rear wheel are in air.
•
Open both plastic covers using proper tools.
•
Easily take the motor cable out from right of the scooter.
•
Use 15-18 hex to disassemble the nuts and motor.
•
Remember the exact order and place of washers on each motor side.
•
Use professional spoons (not plastic or small ones) to dismount tire from the motor. Do it
carefully and don’t damage the motor, rim, tire and tube. Use liquid soap around the rim to
slide tire out from the rim.
•
Fix or replace the tube.
•
Put the tire back in place. You can use a liquid soap to do it easily. Use only hands without
any tool.
•
Pump the wheel up to 45 psi to check that the repair has been completed.
•
To assemble the device, follow the same steps but reversely.
Lubrication
– Apply a little amount of lubricating oil or lubricant in the clutch sleeve folding handle
every six months.
NOTE:
Don’t use WD40 (anti-rust oil) to lubricate it. Don’t lubricate the front and rear part. If you are
not sure, ask an expert.
Tire
– if the brake performance gets worse, use a line brake regulator to adjust it to achieve the best
braking effect. It the braking or brake sensitivity is still bad or you can hear an unusual noise from the
braking system, replace the brake pads and contact a service.
This product is equipped with lithium battery that can recharged for 800 times. If the battery gets
empty in a short time, it should be replaced.
TROUBLESHOOTING
If the product doesn’t work normally, check it following the points below:
•
Check if the power switch is on or not
•
Check the battery power
•
Check brake
•
Check that all sockets and connectors are clean and right
If everything seems to be right and the scooter still doesn’t work, contact the service.
