22
Securing the User in the Restraint
Once the CSI-2000 Positioning Restraint System has been properly fi tted
and installed in the vehicle, follow these instructions to secure the user in
the restraint.
1. Open the harness and move the harness straps to the side of the
restraint.
2. Place the user in the restraint with his/her back positioned against
the back rest in as upright a position as possible.
3. Verify that the harness straps are located in the slots above, but
closest to the top of the user’s shoulders.
4. If the harness straps are not in the appropriate position, move them
according to the instructions provided in
Adjusting the Harness
Height.
5. Place the harness shoulder straps over each of the user’s shoulders
making sure that the straps are not twisted or binding on any object.
6. Fasten the metal latch on each shoulder strap securely into the
buckle.
7. Fasten the plastic chest clip and position it in the middle of the users
chest — aligned with the armpits of the user.
8.
Check to ensure the harness fi t is snug. If needed, adjust the
harness fi t as noted in
Adjusting the Harness Fit.
9. To remove the user from the restraint system, reverse steps outlined
above.
