Top
Shaft
Mount
with
Racks
Slotted Adjustment Holes
Step 1
Weight Bar Assembly
Step 2
Linear Bearing Shaft
Weight Holder
Step 3
Smaller diameter Weight Holder shaft
4 - 3/8” x ¾”L Bolts
4 - 3/8” Flat Washers
Step 4
4 - 3/8” x ¾”L Bolts
4 - 3/8” Flat Washers
Bottom
Shaft
Mount
with
Slotted Adjustment Holes
Setscrews
Step 1: Position the Red Weight Bar Assembly on the Hooks of the front Racks.
(NOTE: The SCS-1 can also be installed on the rear Racks as shown on the next page.)
Step 2: Slide a Linear Bearing shaft into one of the Weight Holders. Orient the Weight Holder as shown.
Place a Bottom Shaft Mount onto the Shaft assuring it is fully seated and tighten the
setscrews. Next, place a Top Shaft Mount on the Shaft before positioning it into the Cage (do not
tighten Top Mount setscrews at this time)
Step 3: Gently guide the small diameter shaft of the Weight Holder into the Red Weight Bar Assembly
and secure the Top and Bottom Shaft Mounts to the Cage using:
Four (3/8” x ¾”L Bolts)
Four (3/8” Flat Washers)
(Finger Tighten Only)
Step 4: Repeat Steps 2 and 3 for the second side Linear Shaft and Weight Holder using:
Four (3/8” x ¾”L Bolts)
Four (3/8” Flat Washers)
(Finger Tighten Only)
Page 4