Inspiration Pursuit Exercise Cycle, Owner'S Manual

Page: 7 / 20

7
ASSEMBLY INSTRUCTIONS
Step 1. Attach the stabilizers
1. Attach the front and rear stabilizers with the nuts, bolts
and washers as shown in the diagram.
2. Be sure to fit the parts in the same order as the diagram.
Make sure the bolts are fully tightened with the spanner.
Step 2. Attach the front post
1. Attach the tension control to the front post with the
screw. Turn the tension control to highest level to give
maximum length of cable for fitting the front post. Hook
the tension cables together as shown. (You may have to
pull firmly downwards on the upper cable to make it fit
underneath the bracket of the lower cable)
2. Connect the computer cable as shown and make sure it’s
fully connected.
3. Slide the front post tube over the front post mounting.
4. Secure in place using the bolts and washers as shown
and be sure to fit them in the same order as the diagram.
Make sure the bolts are fully tightened with the allen key.
Part No. 19 x 4
Cap nut
Part No. 18 x 4
Curve washer
Part No. 20 x 4
Spring washer
Part No. 16 x 4
65mm carriage bolt
Part No. 18 x 4
Curve washer
Part No. 12 x 1
50mm machine screw
Part No. 20 x 4
Spring washer
Part No. 21 x 4
15mm round allen head bolt
Put the cable in the opening.
NOTE: Turn tension to
highest level.
STEP A
STEP B
STEP C
STEP D
The silver part of the cable can be
pushed away from the
control unit to allow it to fit
inside the front post.
This is how it looks when fixed in
position.