4
1
2
3
9
Menu
set up
5
4
5
Pre-Setting No.
Unit
selection
Set Torque Value
Pre-setting
No.
:
M2
Pre-setting No.
:
M1
Press
M
Press
M
Pre-setting
No
.:
M3
Press
M
Pre-setting
No
.
9
:
M9
*
Note1,2,3
Note
:
1
.
The maximum capacity for “Pre-setting No.” is 9 sets.
2 .
The “Pre-setting No.” is in sequential.
Unit selection : in-lb
Pre-setting
:
N-m
Press
U/S
Press
Unit selection : ft-lb
U/S
Unit selection : kg-cm
U/S
Increase target torque value
Pre-setting torque value
Press
Press
Decrease target torque value
Note: The “Unit selection” cycles through all modes.
^
^
Set Peak
/
Track mode
Track
mode
Long press
Set Peak/Track mode
Clear record
U/S
Press or
^
^
Press
Record No.
U/S
*
Note 1.
Press
U/S
*
Note 1.
Peak hold mode
Press
U/S
Start
*
Note 1.
C
Target value
Apply torque
Current torque value
Reach 80% of target torque
Current torque value
( ( ( ( )) ) )
Buzzer
*
Note 2.
Reach target torque
Note
:
1
.
If
is appeared, that means this torque tester has ever been
2.
When 80% of the target torque is reached, the green LED will begin
to flash and the alarm tone will beep intermittently.
3
.
When the target torque is approached, both green and red LED
light on and buzzer sounds.
( ( ( ( )) ) )
Green LED
Reach 80% of target torque
(( ( ( )) ) ) ( ( (( )) ))
Note 3.
*
Buzzer
Red LED
Approached
target
torque
Press
Peak hold/Track mode selection
for selection
Track mode operation
applied more than 110% of torque of the spec.
(System initial)
