8
NS-IR10BK6
www.insigniaproducts.com
Storing your iron
1
Turn the temperature control dial to OFF and set the steam control knob to 0 (no
steam).
2
Unplug the iron.
3
Pour any remaining water out of the water reservoir.
4
Stand the iron upright and let it cool down completely.
5
Wind the power cord around the iron.
6
Always store the iron in an upright position.
Safety protective cut-out
In the unlikely event of the thermostat failing, the protective cut-out operates to prevent
the iron from overheating. If that occurs, the iron should be taken to the nearest
authorized service facility.
Troubleshooting
CAUTION:
Do not try to repair your iron yourself. Doing so invalidates the warranty.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
The iron won’t
heat
The iron may not be
plugged in or the
temperature control dial is
not set correctly.
Plug in the iron and turn up the temperature
control dial. If the temperature indicator
does not come on, does a lamp plugged
into the same outlet turn on? If it does, there
is a problem with the iron. Contact customer
service.
Water drips from
the holes in the
sole plate
The chosen temperature is
too low and does not allow
the formation of steam.
Set the temperature control dial in the
steam range (from •• to MAX).
You are using steam while
the iron is not hot enough.
Wait until the temperature indicator turns
off.
You are using the Burst of
Steam button too often.
Wait a few seconds between each use of the
button.
There is too much steam
selected.
Reduce the steam rate.
