9
Top Control Dishwasher
www.insigniaproducts.com
Connecting the water line to the water supply
1
Turn off the water supply.
2
Install a hand shut-off valve in an accessible location, such as under the sink. This is optional, but strongly
recommended, and may be required by local codes.
3
Install the hot water inlet line using at least 3/8 in. O.D. copper tubing. Route the line and place it into the brackets
in the groove shown in the figure above (there are two white brackets in the groove on the bottom of the
dishwasher that help keep the line in place), and extend it forward at least 24 in. (60.96 cm) from the rear wall of the
enclosure.
4
Adjust the water heater to a temperature of from 120° F to 150° F (49° C to 65° C).
5
Flush the water line to clean out any debris.
Note:
The hot water pressure must be between 20 and 120 psi.
5.3 - 7.3 in.
(13.5-18.5 cm)
from cabinet
2.5-3.5 in. (6.5-9.0 cm)
The water supply
line (the square tie
is for the fixed
water supply line.)
The power cable (the square
tie is for a fixed power cord.)
