21
Top Control Dishwasher
www.insigniaproducts.com
Step 14: Connecting the electrical power
Turn off the electricity to the dishwasher’s electrical circuit.
Skip this step if your dishwasher is equipped with a power cord.
Make sure that the electrical power is turned off at the source.
1
Remove the junction box cover from the power supply junction box on the wall.
2
Locate the three dishwasher wires, (white, black, and green) with stripped ends, then insert the dishwasher
wires through the small hole in the junction box.
3
Secure the house wiring to the bottom of the junction box with a strain relief fitting.
4
Use wire nuts to connect incoming ground to green, white to white, and black to black.
5
Replace the junction box cover. Make sure that no wires are pinched under the cover.
Warning
• If your house wiring is not 2-wire
with a ground, a ground must be
provided by the installer.
• If your house wiring is aluminum, be
sure to use cUL/UL Listed
anti-oxidant compound and
aluminum-to-copper connectors.
You’ll need:
Junction box
White to white
Black to black
Ground to green
Insert wires through strain relief fitting and tighten
Phillips screwdriver
Wire nuts (UL listed)
Strain relief (for
electrical connections)
NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0649_Install MAN_V3_ENG.fm Page 21 Thursday, July 27, 2017 9:21 AM
