9 of 18
An Alliance Technology Company
600 Dekora Woods Blvd. Saukville, WI 53080
Toll Free: 800-488-8177 Local: 262-268-9330 Fax: 262-268-9952
An Alliance Technology Company
A flashing YELLOW LED indicates the external
power source is low. The advanced Xpress
Command Module may continue operating
indefinitely in this state as long as the power level
does not decrease further.
An illuminated YELLOW LED indicates the
external power source is low and the Xpress
Command Module will shut down within 30
seconds.
Immediately disconnect the Command Module for
the external power source. Reconnect the unit to an adequate 13.8-
15Vdc or 110/220Vac power source.
The yellow DC low LED is utilized as a short circuit indicator. When system power
levels are nominal, a slow flash is used to indicate that a short has been detected. If
the system is in low power mode and the DC low LED is already flashing quickly, a
short circuit condition is indicated by blanking approximately every fifth blink. The
combination situation will thus evoke the pattern: blink, blink, blink, blink, off,
blink….This cycle will repeat approximately every two and a half seconds
DC low (yellow)
Off - power levels normal
Slow Blink – short circuit detection
Fast Blink – low power
Interrupted fast blink – low power and short circuit detection
On (steady) – shutdown condition (shutdown will occur in 30 seconds)
When connected to an external supply, 13.8-15Vdc or 110/220Vac power source, the
batteries will recharge and the GREEN LED will flash indicating the batteries are
charging. BATTERIES ARE FULLY CHARGED WHEN GREEN LED IS
ILLUMINATED AND NO LONGER FLASHING. We recommend leaving the 1200
Command Module plugged in overnight for a full charge.
The green flashing or steady light will only be visible when the unit is on. However,
the unit does charge if plugged in with the unit off.
The unit will charge when plugged in while operating the unit.
Verify the camera image is displayed on the LCD screen.
