Edgeport Industrial Installation Guide (90000409 Rev. C) – Page 18
Regulatory & Other Information
© 2004 Inside Out Networks, Inc. Digi, Digi
International, the Digi logo, the Digi
Connectware logo, Inside Out Networks, the
Inside Out Networks logo, Edgeport,
and Hubport are either trademarks or
registered trademarks of Digi International,
Inc. in the United States and/or other
countries. All other trademarks are the
property of their respective holders.
Information in this documentation is subject
to change without notice and does not
represent a commitment on the part of
Inside Out Networks Inc.
Inside Out Networks provides this document
“as is,” without warranty of any kind, either
expressed or implied, including, but not
limited to, the particular purpose. Inside Out
Networks may make improvements and/or
changes to this documentation or to the
product(s) and/or program(s) described in
this documentation at any time.
Inside Out Networks assumes no
responsibility of any errors, technical
inaccuracies, or typographical errors that
may appear in this documentation, nor
liability for any damages arising out of its
use. Changes are made periodically to the
information herein; these changes may be
incorporated in new editions of the
publication.
For U.S. Government use:
Any provision of this document and
associated computer programs to the U.S.
Government is with “Restricted Rights.” Use,
duplication, or disclosure by the government
is subject to the restrictions set forth in,
subparagraph (c) (1) (ii) of the Rights in
Technical Data and Computer Software
clause of DFARS 52.277-7013.
For non-U.S. Government use:
These programs are supplied under a
license. They may be used, disclosed,
and/or copied only as supplied under such
license agreement. Any copy must contain
the above copyright notice and restricted
rights notice. Use, copying, and/or
disclosure of the programs is strictly
prohibited unless otherwise provided for in
the license agreement.
Federal Communications Commission
(FCC) Regulatory Information (USA only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving
antenna.
•
Increase the separation between the
equipment and the receiver.
•
Connect the equipment into an
outlet that is on a circuit different
from the receiver.
•
Consult the dealer or an
experienced radio/TV technician for
help.
Warning: The connection of a non-shielded
interface cable to this equipment will
invalidate the FCC Certification for this
device.
FCC Regulation - Part 15
Declaration of Conformity (DoC)
This device complies with the requirements
of the Code of Federal Regulations listed
below:
FCC Title 47 CFR, Part 15 Class B for a
digital device.
Operation is subject to the following two
conditions:
This device may not cause harmful
interference, and
