InPower LLC
8311 Green Meadows Drive
Lewis Center, Ohio 43035
740-548-0965
www.InPowerLLC.com
© Copyright 2014 InPower LLC
ITM150 Owners Manual
Page
4 of 8
Document: OM-175
Version Code: B
Date: Feb. 28, 2014
Date: May 27, 2014
5. Wiring Instructions
WARNING
!
Make sure that the vehicle battery power is disconnected during installation of the interlock
and lift system. Reconnect the battery when the system installation is complete.
Circuit 1 Wiring (Shiftlock Solenoid & Shifter Wiring)
1. Remove center console cover held on by 4 screws. (See Figure 1)
2. Unplug 2-pin shiftlock solenoid connector on bottom left side of the shifter. Always insert and remove
connectors by gripping the connectors. Do not pull on the wires.
3. Unplug 10-pin shifter connector on bottom left side of shifter. This should be located just above the 2-pin
solenoid connector. (See Figures 2 and 3)
4. Plug the 10-pin connector on the T-harness into the 10-pin connector on the shifter.
5. Plug the 2-pin connector on the T-harness into the 2-pin connector on the solenoid.
6.
Affix the sensor beside the shifter shaft using the two provided screws. It is important that the sensor is
angled with the corner beside the shifter so that it detects the shifter position accurately. (See Figure 3)
Figure 1. Diagram of the ProMaster center console.
Figure 2.View of the ProMaster shiftlock solenoid and
shifter.
Figure 3. View of proper placement of sensor beside
the shifter shaft.
