INOXPAN Pando V1550e, Installation Manual

Page: 12 / 72

INOXPAN S.L.
Please read these safety and installation instructions before using the motor.
Motors should only be used when connected to the hood. If there is a risk of water reaching
the motor through the conduits it will be necessary to provide exterior protection.
External motors are not waterproof; they are not apt for installing exposed to the elements
without special protection.
Once installed, make sure that no moving parts are accessible. Roof motors should not be
used in dangerous environments and not be directly connected to active chimneys (wood
burning, etc.).
WARNING! Before usage or any maintenance operations are carried out, make sure the
power is disconnected, (cut-off switch or differential) and make sure the impeller is
completely stationary.
WARNING!
Motor fans have blades with sharp edges that can cause injury.
WARNING! Take care when opening the access cover for maintenance of the boxes, as
fans with the motor installed on the cover are relatively heavy.
All Pando roof motors are packaged for normal handling during transport. When handling,
use adequate elevation equipment to avoid damaging the motor and injuring personnel.
WARNING!
Do not lift the fans by their cable, the connection box, the impeller or the suction
cone.
Avoid impact and shaking of the equipment. Store the motors in a dry place and protected
from the elements until final installation.
An installation manual with illustrations and explanations is included.
The motor must always be connected to an extractor hood,
never directly to the mains.
Bear in mind the safety information given above. Installation, electrical connection and start-
up should only be carried out by authorised/specialised personnel.
The motor must be installed in such a manner that its vibrations are not transmitted to the
conduits or structures of the building. Make sure the motor is firmly and stably secure and that
it is level.
WARNING! This motor must not be installed upside down. The fan should be installed in such
a manner that maintenance and repair operations can be carried out simply and safely. Noise
disturbance can be avoided by installing a silencer (Not included, but available).
EN
– SAFETY INFORMATION
EN
– TRANSPORT AND STORAGE
EN
– INSTALLATION
12