5.3. TRANSPORT AND STORAGE
The MB blenders are often too heavy to be stored manually.
Use an appropriate means of transport.
Use the points which are indicated in the drawing for lifting the blender.
Only authorized personnel should transport the blender.
Do not work or walk under the heavy loads.
Lift the blender as indicated below:
- always use two support points placed as far apart as possible.
ATTENTION
- secure the supports so that they will not move.
See chapter
to consult the dimensions and weight of the blender.
During the transport, disassembly or assembly of the blender, there is a risk of loss of
stability and that the blender could fall down and cause damages to the operators. Make
sure that the blender is properly supported.
5.4. LOCATION
Place the blender as close as possible to the suction tank whenever possible below the liquid and
leaving enough space around to can access the blender and the motor. If necessary, consult in chap-
te
r 9. Technical Specifications
the dimensions of the blender.
Once a place is chosen, the blender should be mounted on a flat and level surface.
Install the blender so as to allow proper ventilation.
If the blender is installed outdoors, it should be covered by a roof. Its location should
allow easy access for inspection or maintenance operations.
5.4.1. Excessive temperatures
Depending on the fluid to be mixed, high temperatures can be reached inside and around the blender.
ATTENTION
ATTENTION
02.020.32.0004
Installation
INOXPA S.A.U.
02.020.30.02EN · (0) 2022/02
10
