Safety
INOXPA S.A.U.
·
01.611.30.08EN · (0) 2020/02
5
3. Safety
3.1. WARNING SYMBOLS
Safety hazard for people in general and/or for equipment
Electric hazard
Important instruction for the protection of the equipment and its functions
3.2. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual carefully before installing and starting the pump. Contact INOXPA in
case of doubt.
3.2.1. During the installation
9. Technical Specifications of chapter 9
Never start the pump before connecting it to the lines.
Check for proper specifications of the motors, especially it its working conditions create an explosions
hazard.
During the installations, all the electric work should be carried out by authorized personnel.
3.2.2. During operation
Technical Specifications of chapter 9
should always be observed. Under no circumstances can
the specified limit values be exceeded.
NEVER touch the pump or the pipework during operation if the pump is being used for transferring
hot liquids or during cleaning.
The pump contains moving parts. Never place your fingers inside the pump during operation.
NEVER operate with the suction and discharge valves closed.
NEVER spray water directly on the electrical motor. The standard motor protection is IP55: protection
against dust and water spray.
3.2.3. During maintenance
Technical Specifications of chapter 9
NEVER disassemble the pump until the pipes have been emptied. Remember that liquid will remain
inside the pump’s pump casing (if does not have a purge). Bear in mind that the pumped liquid may
be hazardous or extremely hot. Consult the regulations in effect in each country for these cases.
Do not leave loose parts on the floor.
ALWAYS disconnect the electrical power to the pumps prior to carrying out any maintenance.
Remove the fuses and disconnect the cable from the motor’s terminals.
All electrical work must be carried out by authorized personnel
ATTENTION
