Maintenance
18
INOXPA S.A.U.
· 01.611.30.08EN · (0) 2020/02
When installing the different parts and seals, use soapy water to allow them to slide better.
8.6.2. Mechanical seal
Disassembly
•
Follow the disassembly procedure described in the preceding section.
•
If the protections (47A) were not removed previously, remove them now.
•
Loosen the pins (55) to remove the seal ring (31).
•
Remove the seal cover (09) to pull out the seal at the same time as the mechanical seal (08).
•
Finally, gently remove the stationary part of the seal, which has remained housed inside the seal cover.
Assembly
•
Mount the fixed part of the mechanical seal (08) and the O-ring (80) to the seal cover (09).
•
Place the cover on the bearings support (06A).
•
Slide the rotary part of the seal (08) into the shaft complement (26).
•
Place the seal ring (31) on the shaft and fasten it with the pins (55) according to the following assembly
dimension:
ATTENTION
0
1
.6
1
1
.3
2
.0
0
0
9
