4
1. Safety
(0) 2018/05
1.4.2.
During operation
Always take the Technical specifications in chapter 8
into consideration. The specified limit values shall
NEVER be exceeded under any circumstance.
NEVER touch the valve and/or piping that is in contact with the fluid during operation. If the
process involves hot products, there is a risk of burns.
The valve contains parts that move in a linear fashion. Do not place hands or fingers in the
valve closing area. This can cause serious injury.
1.4.3.
During maintenance
The Technical specifications in chapter 8 should always be observed.
NEVER disassemble or remove the valve until the pipes have been emptied. Bear in mind that
the fluid in the pipe may be hazardous or extremely hot. Consult the regulations in effect in
each country for these cases.
Inside the actuator, there is a spring with an applied load, and the steps specified in this
manual must be followed when performing maintenance operations to avoid injury.
Do not leave loose parts on the floor.
All electrical work must be carried out by authorised personnel.
1.4.4.
Compliance with the instructions
Any failure to comply with the instructions may impose a risk to the operators, the environment and the
machine, and may ultimately result in the loss of any right to claim damages.
Failure to comply may entail the following risks:
Failure of important machine/plant functions.
Failure of specific maintenance and repair procedures.
Threat of electrical, mechanical and chemical hazards.
Placing the environment at risk due to the substances released.
1.4.5.
Warranty
Any warranty will be void immediately and lawfully; additionally, INOXPA shall be compensated for any
civil liability claims submitted by third parties, in the following cases:
The installation and maintenance work has not been carried out following the instructions in this
manual.
The repairs have not been made by our personnel or have been made without our written
authorisation.
The parts used are not INOXPA genuine parts.
Modifications have been carried out on our material or equipment without written authorisation.
The material or equipment has been improperly used, has been used carelessly, or has not been
used according to the instructions and their intended purpose, specified in this manual.
The general terms of delivery already in your possession are also applicable
The machine may not undergo any modification without prior approval from the
manufacturer. For your safety, only use original spare parts and accessories.
The usage of other parts will relieve the manufacturer of any liability
Please do not hesitate to contact us in case of doubts or if further explanations are required regarding specific
data (adjustments, assembly, disassembly, etc.)
