INOXPA HLR, Installation, Service And Maintenance Instructions

Page: 22 / 48

(A) 2021/11 7.Maintenance 21
7.5. PUMP ASSEMBLY
7.5.1. Shaft assembly
Pumps Size 0:
• Check that the O-ring (80E) has not been damaged and attach it
with a little grease or oil in the correct position of the bottom cover
(12B).
• Attach the rear cover and fix it on with screws (51C).
• Place the key (61A) in the driveshaft (05).
Pumps Size 1, 2, 3, 4:
• Ensure that the Klingerit seal (18A) - in the case of pump size 4
check the O-ring (80E) - is in good condition, or if necessary replace
it with a new one, and fit it to the gear case (06).
• Make sure to reassemble the pump with the driveshaft (05) in the
left or right position just as it was before disassembling.
• Introduce the shaft assembly into the gear case (06) taking care
when sliding the shaft (05) driven by the retainer (88).
• Use a Nylon hammer and lightly tap the shafts (05 and 05A) until
the bearings cover (12) is well fixed to the gear case (06).
•
Fix the bearings cover (12) to the gear case (06) with the washers
and screws (53A and 52).
• Place the key (61A) in the driveshaft (05).
7.5.2. Filling with lubricant oil
• Remove the oil plug (85) located at the top of the gear case (06).
• Fill the gear case (06) with lubricant up to the level in the middle of
the peephole (86).
See 7.1.3
Oiling to consult type and quantity of oil.