Generalities
4
INOXPA S.A.U.
20.006.30.02EN · (0) 2021/09
2. Generalities
2.1. INSTRUCTIONS MANUAL
This manual contains information about the reception, installation, operation, assembly, disassembly and
maintenance of the BFI vertical agitator.
Carefully read the instruction prior to starting the agitator, familiarize yourself with the installation, operation and
correct use of the agitator and strictly follow the instructions. These instructions should be kept in a safe location
near the installation area.
The information published in the instruction manual is based on updated data.
INOXPA reserves the right to modify this instruction manual without prior notice.
2.2. COMPLIANCE WITH THE INSTRUCTIONS
Not following the instructions may impose a risk for the operators, the environment and the machine, and may
result in the loss of the right to claim damages.
This non-compliance may result in the following risks:
•
failure of important machine/plant functions,
•
failure of specific maintenance and repair procedures,
•
possible electrical, mechanical and chemical hazards,
•
risk to the environment due to the type of substances released.
2.3. WARRANTY
The conditions of the warranty are specified in the General Sales Conditions that have been delivered at the time
of placing your order.
The machine may not undergo any modification without prior approval from the manufacturer.
For your safety, only use original spare parts and accessories.
The usage of other parts will relieve the manufacturer of any liability.
Changing the service conditions can only be carried out with prior written authorization from INOXPA.
The non-compliance of the prescribed indications in this manual means misuse of this gear on the technical side
and the personal safety and this, exempt INOXPA of all responsibility in case of accidents and personal injuries
and/or property damage. Also, excluded from the warranty all breakdowns caused by improper use of the gear.
Please do not hesitate to contact us in case of doubts or if further explanations are required regarding specific
data (adjustments, assembly, disassembly, etc.).
