© 1997 Inovonics Wireless Corporation LIT-FA416-INSTALL
4
02304e 23-Oct-02
Features of the FA416 include:
•
Fully supervises up to 16 FA transmitters.
•
Outputs can be configured Normally Open or Normally Closed via
Output select jumper
. (One
configuration for all outputs.)
•
For N/O configuration, output is open relative to ground. On activation, output pulls to common ground.
•
For N/C configuration, output is held at common ground. On activation, output releases to open circuit.
•
Technicians can observe output function by monitoring voltages between channel outputs and power on
the FA416 or resistance on the FA416R relay outputs.
•
Transmitter, receiver and output options are factory assigned. They may be changed with the FA116
Executive Programmer or with the FA104 (upgraded C104) programmer.
•
Intelligent global fault output for tamper, low battery and inactive transmitters. For example, if one of the
alarm outputs is assigned to monitor low battery faults, the fault output automatically becomes tamper and
inactive only.
•
Manual and/or electronic reset of the receiver.
•
Factory default programming: "Alarm" and "Inactive" outputs are programmed to follow transmitter status;
"Tamper" and "Low battery" outputs are latching. Latched outputs require the receiver to be reset.
•
Simple restoral to factory defaults.
•
Automatic exit from programming after 4 minutes of inactivity.
•
Optional FA516 display module available.
•
Cabling knockout in housing base.
•
Cabling port with separate shutter.
•
Case tamper switch and terminal block for connection to panel zone.
Additional features of the FA416D include:
•
Status LEDs on the display module show transmitter activation, tamper, low battery and inactive.
•
The
Programmed LED
blinks when the point IS NOT programmed, is on steady when the point IS
programmed.
Additional features of the FA416R and FA416DR include:
•
Form C relays for alarm and fault outputs.
