5
If the user press [CH] button once during the channel setting, the LED will blink twice every 1.6
seconds to indicate the unit is set to channel 2.
If the user press [CH] button again, the channel number will be advanced to channel 3 and the
LED
will blink 3 times and so on.
The maximum channel number is ‘5’ and the unit will be scrolled back to channel ‘1’ at the 5th
press of the [CH] button.
7. [°C/°F] Button
Press to toggle unit °C (Centigrade) or °F (Fahrenheit).
8. [RESET] Button
Press to hardware reset the unit to factory setting.
SETTING PROCEDURE TO LINK UP WITH the Frame UNIT
The remote sensor is designed for easy set up with no wire installation. The following steps are
required to be done in conjunction with the procedure descript in section 6 on ‘How to install remote
sensor’
1. Remove the bracket stand.
2. Unlock two latches in the bottom to release the semi-transparent jacket.
3. Slide down the battery door at the rear side.
4. Insert x2 AAA batteries according to polarity marking on the battery compartment.
5. The LED blinks slowly to indicate it is set to channel 1 and the user can change it to other channel
by pressing the CH key.
6. The temperature and humidity of the sensor will appear on the selected channel of the Frame unit
if it is linked up with the receiving unit successfully.
7. Close the battery door and use two latches in the bottom to lock it with the semi-transparent
jacket.
Follow the same procedure (1 to 7) to register other remote sensors.
NOTE: For user purchasing more than one remote sensor, he must set the sensors to
different channel in the start up to avoid conflicts.
GETTING STARTED
The CPN03 Color Weather Station was designed for easy set up. For best operation, the following
steps are required to be done in the proper sequence.
a.
Connect the adaptor power plug into the power socket of the Frame unit, and then plug in the
power adaptor into the wall Jack;
b.
Weather station battery installation
The batteries must be installed into the weather station prior to start a RCC reception because
they supply the internal power for RCC reception
