5
3.
Installation and Commissioning Dental Cart
3.1
Unpacking & Set-Up
1. Unpack carefully from crate. Tools required: flat head screwdriver and paper towel. (Packaging should be
kept for future shipping purposes, in the event the entire unit needs to be returned for service).
2. Lift lid on cabinet and remove Operation Guides (Dental Cart & JUN-AIR® Compressor), handpieces, hoses,
foot pedal, water bottles and black air intake filter.
3. Adjust height by turning the black cart height adjustment knob on center pole. Support cabinet
while adjusting knob. See diagram on Page 4 (Item 12).
Before
After
4. Remove small yellow cap from air intake nozzle on air
compressor and store in cabinet (See Figure 3.1).
- Place black intake filter over air intake nozzle,
press firmly to secure (See Figure 3.2).
Note:
Filter should be changed annually. Item # 54918.
Figure 3.1
Figure 3.2
5. Fill water bottles with distilled water and attach under left side of cabinet. See diagram on Page 4 (Item 5).
6. Compressor is filled with oil at factory. Check bubble window to insure oil level
falls in between the MAX and MIN (See Figure 3.3).
7. Following manufacture
r’
s instructions, carefully attach handpieces (High/Low).
8. Attach a KLAW
™
tip to the Piezoelectric scaler handpiece, tighten with wrench
until snug.
Warning:
Do not over tighten KLAW
™
as it may damage the Piezoelectric handpiece.
Note:
Piezoelectric scaler instructions are located on Pages 9-11; please see before attempting to operating unit.
9. Plug power strip located under cabinet into standard 110V outlet.
Figure 3.3
10. Ensure the following are plugged into power strip: Piezoelectric scaler, Fiber-Optics (if available) and
compressor.
11. Turn on power strip to supply power to cart (switch
–
red light).
12. At 120 PSI, open storage tank discharge valve if it is not already open (See Figure 3.4 & 3.5). This will
provide pressure to High Speed, Low Speed and Piezoelectric handpieces and Air & Water systems.
Opened
Closed
Figure 3.4
Figure 3.5