Rev. NC
October 1, 2003
Page
8
6.
Once rinsed, install the filters back into the unit. The 10-2801 filter should be installed in
the filter port that is on the left side of the faucet (as you face the front of the machine).
The 10-7002 should be installed in the filter port on the right side of the faucet.
Machine sanitizing:
Note: This sanitizing procedure basically involves injecting water doped with 200 ppm
of chlorine into the cold-water drain line of the machine. This chlorinated water will
flow through the drain system into the cold tanks. When the cold tanks are filled with
water, the sanitizer will sit for 10 minutes before being flushed out of the system.
Flushing will involve fresh tap water flow into the back inlet fitting, through the faucet.
7.
Remove the 4 screws
that secure the top cover
(top cover is different
than the access door you
opened in step 3).
Remove the top cover
and set aside.
8.
Refer to Figure 2.
Remove the ¼” plastic
tube that connects the
outlet of the cold tank to
the inlet of the top
solenoid valve (outlet
solenoid) and set aside.
9.
Connect a length of ¼”
tubing to the outlet of
the cold tank and route that tube to a sink, floor drain, or carboy.
Caution: Wear Safety
Glasses. Secure the tubing sufficiently to prevent any unwanted repositioning or
movement. This is the tubing that will flow sanitizer solution when the tanks are
filled, and all necessary precautions need to be taken to prevent unwanted
sanitizations of eyes, clothing, and carpets
.
10.
Plug the tap water connection (inlet bulkhead fitting) that the tap water connects into on
the back of the machine (see the Figure on Page 9).
11.
Remove the stainless steel cap off of the cold water drain line on the back of the machine.
Summary of Contents for uvf3 10-VMHC3
