PAGE 19 OF 38
Headphone Pairing
STEP 1:
To put your headphone in pairing mode, press and hold the MFB button (5)
for 2 seconds until the headset powers on and enters pairing mode automatically
after 5 seconds. LED indicator (7) will flash
BLUE
and
RED
alternately. Note: the
headphones will power off after 5 minutes if no Bluetooth device is connected.
STEP 2:
Activate Bluetooth on your smartphone (or other Bluetooth-enabled audio
source) and set it to search for new devices.
iPhone Settings > Bluetooth > On
Android Settings > Bluetooth: On > Scan for devices NOTE: Menus may vary by device
STEP 3:
Select
“
Cervella
-
headset
”
from the list of available Bluetooth devices.
If
necessary, enter four zeros (0000) for pass code or accept connection.
Once
successfully paired, the headphone LED indicator flashes
BLUE
.
Note: Avoid connecting additional Bluetooth devices (other than Cervella device
and headphone connection) to your smart device in order to ensure uninterrupted
audio streaming during treatment.
Active Noise Cancellation (ANC)
ANC Button:
Press the ANC button on the right of the headphone to activate the
noise cancellation and the LED indicator turns green. Press ANC button again to turn
off the noise cancellation and indicator turns off.
Charging the Headphones
Please plug Micro USB into headphone charging port and connect the other side to
the USB charger provided. The Battery Indicator LED (2) indicator turns
RED
while
charging and turns blue when fully charged. Note: The headphone reminds you that
the battery is low every 15 minutes when the battery power is below 10%.
