18
GAME REPAIR
7. Loosen the 4 adjusting bolts on BOTH ends of
the assembly to loosen up the duck belt.
LOOSEN THESE SCREWS
(BOTH SIDES)
8. On the DRIVE MOTOR SIDE of the assembly,
pull the belt to the side and loosen the 2 Allen
set screws that hold the drive roller to the motor
shaft.
9. Loosen the Allen set screws that holds the small
roller bearing to the motor shaft.
10. Remove the 4 screws and nuts that hold the mo-
tor to the assembly.
11. RE-ASSEMBLE IN THE REVERSE ORDER.
12. NOTE: TIGHTEN THE SCREWS THAT HOLD
THE MOTOR TO THE ASSEMBLY JUST TIGHT
ENOUGH TO JUST SQUEEZE THE GASKET
MATERIAL. OVER TIGHTENING COULD
CAUSE SHAFT MIS-ALIGNMENT AND / OR
EXCESSIVE MOTOR NOISE.
13. FOLLOW THE DUCK BELT ADJUSTMENT
PROCEDURES AT THE END OF THIS SEC-
TION.
BELT REPLACEMENT
1. Turn off A.C power
2. Remove cover glass by removing the 4 Allen
screws that hold the glass retainer.
3. Remove the Masonite "pond" covers that are
held in place with Velcro.
4. Remove the wires that are connected to the D.C.
motor. NOTE: MARK THE WIRES TO BE SURE
THE MOTOR DOES NOT RUN BACKWARDS
WHEN THE GAME IS POWERED BACK ON.
IF THE BELT RUNS BACKWARDS THE BELT
COULD BE SEVERELY DAMAGED.
5. Remove the 4 bolts that hold the belt assembly
into the game.
6. Remove the belt assembly from the game. BE
CAREFUL NOT TO SCRATCH THE GAME
WHEN REMOVING THE ASSEMBLY. Place the
assembly on a suitable work surface.
7. Loosen the 4 adjusting bolts on BOTH ends of
the assembly to loosen up the duck belt.
8. On the DRIVE MOTOR SIDE of the assembly,
pull the belt to the side and loosen the 2 Allen
set screws that hold the drive roller to the motor
shaft.
SET SCREWS UNDER BELT
BEARING SET SCREW
9. Loosen the Allen set screw that holds the small
roller bearing to the motor shaft.
10. Remove the 4 screws and nuts that hold the mo-
tor to the assembly.
