DLG-1 Configuration
3
The DLG-1 can be setup to display AFR or Lambda. When configured to
display AFR, it can be setup for any fuel type setting. The configuration can
be done on the gauge itself by utilizing the interface buttons or by connecting
the unit to the LM Programmer software.
Note: The wideband settings are universal, that is, they apply to both
A/F channels (both internal and external.)
3.1
Entering Setup Configuration
The DLG-1 can be configured directly from the gauge itself or by connecting
it to a computer with the LM Programmer software.
3.1.1 Configuration
using
DLG-1’s interface buttons
1.
From the main screen, press and HOLD the left interface button to
put the gauge in setup mode
2.
Pressing either the left or right interface buttons will allow you to
cycle through the 2 different setup parameters in the menu.
3.
Once the desired setup parameter is displayed, press and HOLD the
left interface button to make a change. Once the parameter’s
configuration has been entered it will start flashing.
4.
Make changes by using the left or right interface buttons.
5.
Once in setup mode, pressing and HOLDING both interface buttons
together will move you to the menu or main screen. The gauge will
revert back to the main screen if no there have been no button
presses for 15 seconds.
3.1.2
Configuration using the LM Programmer software
Refer to chapter 4, Logworks 3 & LM Programmer Software Package to gain
access to the software.
1.
Power the DLG-1 OFF.
2.
Disconnect any devices connected to the serial IN port
3.
Connect the OUT port of the DLG-1 to the provided serial
programming cable. Connect the other end of the serial
programming cable to your computer. If your computer does not
have a serial port, you can purchase a USB to Serial adapter from
Innovate Motorsports (P/N 3733) or use any USB to serial adaptor
that includes drivers. Make sure that nothing is connected to the IN
port of the DLG-1
4.
Power up the DLG-1.
