INNOVAIR DC INVERTER QUANTUM
SERVICE MANUAL
w w w . i n n o v a i r . c o m
4
Preparation before use
Note
Preset
Safeguarding the environment
This applianc e is made of rec y clable or re-usabl e material. Scrapping must be carried out in
compliance with local waste disposal regulations. Before scrapping it, make sure to cut off the mains
cord so that the appliance cannot be re-us ed.
For more d etailed information on handling and recycling this product, contact your local authorities
who d e al with the separate collection of rubbish or the shop where you bought the appliance.
SCRAPPING OF APPLIANCE
This appliance is marked according to the European Directiv e 2012/19/EC, Waste Electrical and
Electronic Equipment (WEEE).
This marking indicates that this product should not be disposed
with other household wast e s throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal,recycle it responsibly to promote the sustainable reuse of
material resources. To return your used devic e , please use the r eturn
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
• When charging refrigerant into the system, make sure to charge in liquid state,if the
refrigerant of the appliance is R41 QA.Otherwise, chemical composition of
refrigerant (R41 0A) inside the system may change and thus affect performance of
the air conditioner.
• According to the character of refrigerant (R410A,the value of GWP is 2088), the
pressure of the tube is very high, so be sure to be careful when you install and repair
the appliance.
• If the supply cord is da maged, it must be replaced by the manufacturer, its
service agent or si milarly quali fied persons in order to avoid a hazard.
• The air conditioner must be installed by a professional engineer.
• The temperature of refrigerant circuit will be high, please keep the
interconnection cable away from the copper tube .
Before using the air conditioner, be sure to check and preset the following.
• Remote Control presetting
Each tim e after the remote control is replaced with new batteries or is energized, re mote
control auto presetting heat pump.If the air conditioner you purchased is a Cooling Only one,
heat pump remote controller can also be used.
• Back-light function of Remote Control(optional)
Hold down any button on remote control to activate the back light. It automatically shuts off
10 seconds later.
Note: Back-light is an optional function.
• Auto Restart Presetting
The air conditioner has an Auto-Restart function.