MU8002-012ENEU rev03
8
-3-
XTIRPA SYSTEM REQUIREMENTS
IMPORTANT:
If you have questions about the use, care or suitability of the XTIRPA sys-
tem for your application, please contact the Manufacturer INNOVA Public Utility Products
Inc.
IMPORTANT:
Record the product identification information from the ID label in the main
-
tenance and inspection log of this Instruction and safety manual.
IMPORTANT:
Record purchasing date and also date of first use on the maintenance and
inspection log sheet included in this safety instruction manual.
a) The XTIRPA system is intended to be used as part of a personal protection equipment sys-
tem for fall protection, work positioning, personnel handling, materials handling, or rescue,
for use in confined spaces. The XTIRPA system is intended to act as a support structure
or anchor for these uses. The XTIRPA system must be used only with adapters, anchors,
connectors (EN 362), and other components, parts or subsystems that have been certified,
approved and recommended by the Manufacturer.
WARNING:
This system should never be used to transport persons and material at the
same time.
b) Substitutions or replacements made with non-approved adapters, anchors, connectors (EN
362), other components, parts or subsystems may be incompatible, may jeopardize the safe-
ty and reliability of the complete XTIRPA system and may result in serious injury or death,
for which the Manufacturer disclaims all warranties and liabilities whatsoever, user, owner
and purchaser of the XTIRPA system waiving all claims, rights and recourses against the
Manufacturer derived therefrom.
IMPORTANT:
It is imperative to keep the pulling angle at a maximum of twenty-two de-
grees (22°) from the lifeline cable or rope, as to avoid any frontward load unbalance of the
manhole guard and cause it to topple over (see illustration A).
WARNING:
The anti-toppling device A2108-18 must be used while the manhole guard is
being used in V configuration. See illustrations 4 and 5 in Section 5 of the manual.
c) All connectors (EN 362) (hooks, snap hooks, D-rings) must meet the standard EN 362.
d) The manhole guard’s integrated mast must be positioned at the highest point of the area to
be barricaded.
Summary of Contents for XTIRPA IN-8002
Page 22: ...MU8002 012ENEU rev03 22 NOTES...
Page 23: ...MU8002 012ENEU rev03 23 NOTES...