Innova XTIRPA IN-8002, Instruction And Safety Manual, Page: 16 / 24

MU8002-012ENEU rev03 16
8.
A) If a material positioning winch is required,
use the bottom mounting bracket located un-
der the davit arm. Install winch to mounting
bracket and lock with pin attached to winch.
B) Remove the small pulley locking pin. Po-
sition cable over pulley and re-install pulley
using locking pin.
WARNING: It is strictly prohibited to use the material /positioning winch as a fall arrest,
when the winch is positioned on the bottom mounting bracket located under the davit arm.
WARNING: Only adaptors and brackets that are approved, certified and recommended by
the manufacturer are to be used with the XTIRPA system.
9.
A) Remove locking pin located in the mid
section of the davit arm. B) Extend the inner
mast to full extension. Replace locking pin
to secure the davit arm.
IMPORTANT: It is imperative to keep the pulling angle at a maximum of twenty-two de-
grees (22°) from the lifeline cable or rope, as to avoid any frontward load unbalance of the
manhole guard and cause it to topple over (see illustration A).
10.
A) When attaching the safety harness with the lifeline cable or
rope, it is imperative, in order to avoid the manhole guard top-
pling over, that the user tie himself at the front of the XTIRPA
system.
IMPORTANT: Make sure the lifeline cable or rope is positioned directly over the work
area. Use only certified lifeline cable or rope, in perfect working condition, with appropri -
ate specifications, including maximum leverage capabilities, for the intended use of the
XTIRPA system.
WARNING: It is imperative to position the XTIRPA system on a hard and level surface. Do
not use the XTIRPA system on soft ground, such as but not limited to, sand, grass, gravel
and rocks. If you have questions on the use, care or suitability of the XTIRPA system for
your application, please contact Manufacturer.