34
OEM DIAGNOSTICS
Vehicle Inspection Health Report
RESCAN ALL SYSTEMS
Use this function to get the most current diagnostic status for the vehicle under test – particularly as you continue to
troubleshoot each individual control module.
1.
From the “
Scan All Systems
” result page, tap
Rescan All Systems
button at the top right of the page.
2.
Tool generates a new report and updates the “
Scan All Systems
” results page. [
VEHICLE INSPECTION HEALTH REPORT
The
Vehicle Inspection
report, also considered a full
Network Scan
, provides a complete overview of the vehicle’s
current health status. It reports the vehicle’s emission readiness status, system status, service status, dashboard
warning light status, and a RepairSolutions2
diagnostic report.
1.
Follow the
Scan All Systems
steps to connect with the vehicle. [
2.
From the OEM Diagnostics results screen, tap the
Vehicle Inspection
button.
3.
A progress bar appears,
“
Retrieving Vehicle Information...”,
while the tablet scans all of the vehicle’s equipped
modules.
n
It can take several minutes depending on the number of available systems available on the
vehicle being tested. Tap
Cancel
to abort the scan.
n
If the Vehicle Inspection was recently performed, a “...Are you sure?” warning dialog appears
prior to the scan. Tap
Continue
to complete the scan, or tap
Cancel
to return to the previous
screen.
VIEWING THE VEHICLE INSPECTION TEST RESULTS
Scan results are shown immediately following completion of a scan; and can also be viewed later using the
PREVIOUS VEHICLE
function available through the
Menu
or
Home
page. [
Each report begins with a vehicle information tab that includes a
Report ID
, the vehicle’s description (
year/make/
model
), the last six digits of the Vehicle Identification Number (
VIN
) and the odometer reading (
ODO
) at the time the
scan was performed.
Emissions Readiness Monitors Status
Indicates whether the vehicle is ready for an Emissions Test (Smog Check) based on DTCs present, Freeze
Frame data, Monitor Status, MIL (Check Engine Light) status, State/Region, and Engine Type. Results are shown
as “
Complete
” or “
Not Complete
”.
n
Emission Readiness Monitor -
For a “
Not Complete
” result, Drive Cycle Procedures can be
found in the OBD2 Diagnostics screen. [
]