9
GB
water with fresh water. It is advisable to replace the water in the tank at least once a week.
Once the “cooling” function has been activated, the water pump will start to draw water from
the tank, making it pass through the cooling pad; in this way the evaporated air is expelled
with the help of the fan.
Swing Function
Press the “Swing” key to activate the movement of the vertical wings that will start to oscillate
automatically from right to left. This function allows you to direct the air from right to left. The
horizontal wings must be positioned manually to direct the airflow up or down.
How to fill the tank
Check the water level in the tank frequently, making sure that it never goes below the “MIN”
level indicated in the tank itself. The activation of the “cooling” function with an insufficient
amount of water may cause the malfunction of the water pump making void the warranty.
ATTENTION: Before proceeding with the filling of the tank, make sure to first disconnect the
device to the mains.
How to use ice tablets
By inserting the ice tablets into the tank, a fresher jet of air can be obtained.
• Store them for a couple of hours in the freezer.
• Once the water is frozen inside them, the ice boards are ready to be stored in the tank.
Proceed by pouring the water into the tank until reaching the indicated MAX level.
CLEANING AND MAINTENANCE
Dust accumulating on the dust filter may prevent proper air flow. Therefore we recommend to
clean the filter and all its parts regularly, following the instructions below. Before proceeding
with any maintenance or cleaning operation, switch off the appliance and remove the plug
form the main socket. Never clean the product components with flammable liquids. The
vapours may cause fire or explosion
Dust Filter
To remove the dust filter, simply press the two release levels located at the top of the filter down
to remove it. Use a mild detergent and a soft brush to clean and remove dust and dirt from the
filter. Put the filter on again inserting the bottom firstly and pushing the upper part to lock it.
Cooling Pad
After removing the dust filter, the cooling pad is visible. Take out the pad with the appropriate
protection and gently remove the pad. Use a clean, soft brush to remove dust and dirt from
the pad. Rinse with water if necessary, and leave to air dry. Do not use chemical cleaning
solutions that can damage the pad
Water tank
Turn the tank lock lever to a horizontal position and pull the tank towards you to partially
pull it out. Before proceeding with the cleaning, remove any residual water, removing the
plastic stopper on the bottom of the tank. It is advisable to place a container under the tank
