Innohome SGC430-1U3-50, Reference And Installation Manual, Page: 6 / 24

15cm
COOKER
HOOD
Select the mounting location
Measure the installation height. The Heat Sensor should be centred
above the cooker, preferably within Zone 1 (see the diagram below).
It can be attached to the grease filter. It is important to ensure the
minimum distance from the light underneath the hood is 4" (10cm)
(2" (5cm) is enough for LED lamp).
Zone 1 is recommended for best performance.
Mount the Heat Sensor
The Heat Sensor might beep at
this stage indicating that it is not
properly placed on the installa-
tion plate. As this happens, no
further action is required.
If there is a metal mesh grease
filter on the cooker hood, make
sure it is greaseless and dry. Press
at least for a minute from the
opposite side while attaching
adhesive.
Carefully remove the protective
film from the installation plate.
Attach the Heat Sensor with the
LED facing the user.
Attach the installation plate
while the Heat Sensor is on it.
1 2
1a
Zone 2
Zone 1
Radius 6"
(15cm)
Min 4" (10cm)
Min 2" (5cm)
for LED lamp
Zone 1 is immediately
above the middle of the
cooker plates. Max 6"
(15cm) from the centre.
I N S T A L L A T I O N
Zone
1
6