Replace lens
Carefully lift the lens with a
screwdriver. Press down the
IR lens extension (included)
as shown in the picture. The
extension should point directly
upwards at an angle of 90°. If the
extension moves around, check
that it has been inserted
the right way round.
Finding the mounting
position
Measure the distance between
the cooker and ceiling. Place the
Heat Sensor directly above the
center point of the cooker. Make
sure that the surface is clean
and dry.
Mount the Heat Sensor
The Heat Sensor might beep at
this stage indicating that it is not
properly placed on the installa-
tion plate. As this happens, no
further action is required.
Make sure that ceiling is grease-
less and dry. Press at least for a
minute while attaching adhesive.
Carefully remove the protective
film from the installation plate.
Attach the Heat Sensor with the
LED facing the user.
Attach the installation plate
while the Heat Sensor is on it.
CEILING
1
2
I N S T A L L A T I O N
1c
3
10
Summary of Contents for SGC430-1U3-50
Page 14: ...2 USER GUIDE...