4
Function
The motion detector (exterior) detects
people’s movements by measuring differ-
ences in temperature compared with the
surroundings. An evaluation circuit con-
verts the status detected (motion) into
remote commands. The motion detector
(exterior) can be used to control SmartH-
ome devices.
Hazard warning
• Do not open the motion detector (exte-
rior). It does not contain any parts to be
serviced by the user. If a fault occurs,
please contact our service.
• Only operate the in a weatherproof loca-
tion. Do not expose the motion detector
(exterior) to direct contact with rain or
water. Avoid direct sunlight and other
heat radiation.
Commissioning
1
Unlock the wall bracket by simultane-
ously pressing the two locking latches in
the direction of the arrow.
2
Insert the batteries (type AA) ensuring
the correct polarity.
3
Position the wall bracket at a point on a
wall which ensures good coverage of the
desired detection range.
4
Mark the corresponding holes for drilling
through the screw holes on the wall
bracket.
5
Drill each hole with a diameter of 5 mm
and a depth of 35 mm and insert the
dowels.
6
Position the wall bracket in front of the
drilled holes. Secure the wall bracket
with the screws.
7
Insert the base unit by sliding it from
below onto the wall bracket.
8
Integrate the device via the user soft-
ware in the SmartHome system.
General information
eQ-3 Entwicklung GmbH hereby declares
that this device meets the basic require-
ments and the other relevant regulations
laid down in Directive 1999/5/EC.
You can find the complete declaration of
conformity at:
www.eq-3.de/service/downloads.html
eQ-3 Entwicklung GmbH,
Maiburger Str. 36,
D-26789 Leer
Technical data
Name of device
WMDO
Power supply
3x LR6 (Mignon /
AA)
Battery service life
Approx. 2 years
Radio frequency
868.3MHz
Max. transmission
power
10mW
Open air range
Approx. 100m
Receiver class
SRD Class 2
Protection class
IP44
Ambient tempera-
ture
-20°C to +55°C
Dimensions
96x70x90mm
(WxHxD)
Weight
160g
Technical changes reserved.
EN
