Innofit FIT-806, Instructions For Use Manual

Page: 23 / 28

23
GB
The speed pre-set for each program and range are displayed in the table below in bold:
7. TEST Heart Rate Monitor: hold the handrails placing your hands on the sensors in iron for
a few seconds, after a few seconds, the display will show the current heart rate. This value
is for reference only and must be free of any medical value.
The system will emit an alarm “B i-B i ...” 15 times, when a program ends, the system will
automatically switch to manual mode and will continue to operate at 2 km / h, pressing
STOP will reset the system and switch STAND-BY mode.
8. If you do not press any buttons for 10 minutes in standby mode, the display automatically
turns off, press any key to restart your computer.
9. Removing the safety key from the console, the treadmill stops and the display shows “---”
and emits the continue “Bi Bi”. You must turn off the treadmill. The system will restart and
will go into standby mode when the safety key is repositioned.
10. To tilt the platform, lift the orange legs and fasten the two bolts in the hole corresponding
to the desired ring, see image below.
intervallo n. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
P7 2 4 6 2 4 6 2 4 6 2 2 4 6 2 4 6 2 4 6 2
P8 3 5 7 3 5 7 8 5 7 8 5 7 8 3 5 7 3 5 7 3
P9 2 3 3 5 6 9 9 10 10 6 6 8 8 3 5 8 6 6 6 2
P10
4 5 6 7 8 9 10 10 10 9 9 9 8 8 8 9 9 8 6 4
P11 9 10 11 12 12 12 10 10 9 9 12 9 9 12 9 9 10 11 12 12
P12 3 8 3 8 4 9 4 9 12 12 6 6 10 10 4 12 4 12 10 10