IsatDock2 MARINE - User Manual
13
Personal Alert and Assistance Alert
IsatDock2 MARINE supports the IsatPhone
2 Personal Alert and Assistance Button
capabilities for various land and sea based
applications.
The Personal Alert button is located on the front
of the IsatDock2 MARINE. A single button press
on the dock will send an instant GPS position
along with a short message to the recipient/s.
This must be configured on IsatPhone 2 to
enable a user to send an SMS or email to up to
10 recipients. Please refer to the IsatPhone 2
User Manual for further information.
The Assistance Alert feature can be triggered
from the IsatDock2 MARINE by using an
external switch or wireless pendant connected
to the BEAM Alert Loop of the dock. Please
ensure that the Assistance Alert settings in the
IsatPhone 2 have been configured to enable to
send a call, e-mail or SMS.
NOTE
For configuration of Personal Alert and Assistance
Alert, refer to IsatPhone 2 User Manual.
NOTE
Entering the firmware upgrade mode will be
accompanied by a long beep followed by three
short beeps.
Configuration Using Remote
Commands
Configuration instructions or “Remote
Commands” can be sent to the terminal via
SMS, and most settings are supported that are
normally accessible from Falcon. Please refer to
the Falcon user manual for more information.
NOTE
Due to memory limitations it is recommended
that users have no more than 20 SMS messages
in their inbox. If this amount is exceeded the
processing of remote commands and the ability to
retrieve the messages via the Falcon tool may be
compromised.
NOTE
If the BEAM Alert Loop is going to be used
with an external button, remember to enable
this external loop in the Falcon settings. Once
enabled, the loop will be armed and activated
with an open-loop condition, triggering on alert
on the IsatPhone 2.
Configuration
Falcon can be downloaded from:
http://www.beamcommunications.com/
support/isd2marine
Follow the instructions in the downloaded
application to install. Once complete, connect
your PC to the USB port of the terminal and start
Falcon. You can then use the application for a
range of options such as:
•
View the status of the IsatDock2 (signal,
temperature, input voltage)
•
Firmware maintenance
•
Configure different POTS/RJ11 settings
Summary of Contents for IsatDock2 MARINE
Page 1: ...IsatDock2 MARINE User Manual Inmarsat Approved ...
Page 2: ...2 ...
